Please Baidu search SENCO INDUSTRIAL MACHINE AND TOOLS (CHINA)CO.,LTD to find us!

Common Problem

What problems should be paid attention to in the maintenance of plate bending machine

Word:[Big][Middle][Small] QR Code 2020/6/29     Viewed:    



  1. According to the provisions in the lubrication diagram of the machine,oil shall be added to each oil cup lubrication and manual lubrication point as required.

  2. The thickness of the plate is 20 mm,the maximum length is 2500 mm,and the yield limit of the material is less than 250 MPa.

  3. After connecting the power supply,carry out the forward and reverse direction of the lower roll and the up and down movement of the upper roll,and check whether there is abnormal clamping phenomenon in each movement.

  4. Strictly follow the rolling plate processing procedures and operation methods. When the upper roll is lifted to the limit position,pay attention to the safe operation of the equipment.

  5. When the main drive stops,the upper roll can be lifted and lowered,the overturned bearing can be overturned and reset,and the upper roll can be raised.

  6. In the process of operation,if any abnormal phenomena such as irregular noise and impact are found,the machine shall be shut down immediately for inspection.

  7. During the operation,all personnel shall coordinate with each other and follow the command of the person in charge of the rolling plate. If there is no command,it is forbidden to start the machine.

  8. During the rolling operation,pay attention to the hand being pressed by the steel plate and rolling in together with the steel plate.

  9. When lifting steel plate or drum with crane,be careful not to collide with the machine.

  After the end of rolling plate,the site shall be cleared after the completion of work,and the maintenance of equipment shall be done well,and the power supply shall be turned off in time.

Go Back
Print
+86-186-5555-2171
Browse Mobile Station